Insert Output To Manual Feed - Xerox Phaser 6128MFP Service Manual

Error Messages and Codes

Insert Output to Manual Feed

Applicable Error
Initial Actions
3-80
The Manual Feed No Paper Sensor did not detect media when expected during a
duplex job. This troubleshooting procedure applies to this error.
• Insert output to Manual Feed Press OK to continue
• Check the condition of the Manual Feed Detect Sensor actuator.
• Cycle printer power.
• If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Manual No Paper Sensor, PL3.2.13
Left Side Harness, PL10.4.18
MCU Board, PL10.7.7
Troubleshooting Procedure Table
Step Actions and Questions
1 Was media inserted for the second
side of the duplex job?
2 Run the Manual Feed Sensor test
(DI-0) (page 4-39).
Use the actuator to toggle the
sensor output.
Does the sensor operate?
3 Check connectors P/J23 and P/J233
between the MCU Board and the
Manual Feed No Paper Sensor.
Are the connectors secure?
4 Check Left Side Harness continuity.
Disconnect P/J23 from the MCU
Board and P/J233 from the Manual
Feed No Paper Sensor.
Is the harness damaged?
5 Check for +3.3 V at J23 on the MCU
Board.
Is +3.3 V available between J23-6
<=> ground?
Wiring and Plug/Jack Map References
"Map 2 - Feed and Laser Unit" on page 10-7
"Media Feed" on page 10-15
Yes No
Go to step 2. Insert media
when
indicated.
Replace the Go to step 3.
MCU Board
(page 8-57).
Go to step 4. Reconnect the
connectors.
Repair or Go to step 5.
replace the
harness
(PL10.4.18).
Go to step 6. Replace the
MCU Board
(page 8-57).
Phaser 6128MFP Service Manual