Fax/Scanner Parameter Setting
Phaser 6128MFP Service Manual
Life Counters (continued)
Counter Name
Life IU Deve K (Sheet)
Life Manual Feed
Life Tray Sheet
This function reads and writes parameter stored in the Image Processor Board.
Note
Refer to "Chain Link for Fax Parameter Setting" on page A-9 in the Reference
chapter.
To access the Parameter menu:
1. Turn the printer power Off (if the printer is On).
2. Simultaneously press the Up Arrow and Down Arrow buttons and turn on the
printer.
3. The Service Mode menu is displayed.
4. Select Fax/Scanner Diag and press the OK button.
5. Press the Up Arrow or Down Arrow button to find Parameter. Press the OK
button.
Note
Use the Left or Right Arrow button to move the cursor. Use the Up or Down
Arrow button to change the value.
1. Enter the Chain Link number and press the OK button.
2. The value of the parameter is displayed with an *. This is the current value.
3. Enter the appropriate value and press the OK button.
4. Press the Stop button three times to return to the Parameter menu.
5. Press the Up Arrow or Down Arrow button to find Complete. Press the OK
button two times to exit.
Adjustments and Calibrations
6-11