Iot Sensor Testing Procedures - Xerox Phaser 6128MFP Service Manual

IOT Sensor Testing Procedures

Phaser 6128MFP Service Manual
Procedures for testing each IOT sensor using Service Diagnostics.
Interlock Switch
K Mode Sensor
Registration Sensor
Exit Sensor
Warning
Allow the Fuser to cool down before starting the procedure.
1. Enter Service Diagnostics (page 4-4).
2. Open the Front Cover.
3. Perform the Exit Sensor test: Engine Diag > Sensor Test > Exit Sensor.
4. Move the Sensor up and down and check the information on the Control Panel
display. The Low and High values change from 0 up 99.
Tray 2 No Paper Sensor
Manual Feeder Sensor
General Troubleshooting
Exit Sensor
Side Switch
s6128mfp-073
4-33