Copier Error Last Sheet not Copied
Phaser 6128MFP Service Manual
An error in the imaging subsystem was detected. The following troubleshooting
procedure applies to this error.
Applicable Error
•
Copier Error Last Sheet not Copied
Initial Actions
•
Cycle printer power.
•
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Image Processor Board, PL10.6.6
Troubleshooting Procedure Table
Step
Actions and Questions
1
Does the error message disappear
within 70 seconds automatically, or
disappear after pressing the OK
button?
2
Does the error persist when copying,
faxing, or scanning?
3
Print a Configuration page: System
> Information Pages >
Configuration.
Does the error persist when copying,
faxing, or scanning?
4
Cycle system power.
Does the error persist?
Error Messages and Codes
Wiring and Plug/Jack Map References
"Imaging" on page 10-24
Yes
Go to step 2.
Go to step 3.
Go to step 4.
Replace the
Image
Processor Board
(page 8-41).
No
Go to step 4.
To to step 4.
Complete.
Complete.
3-131