Load or Remove Paper from Manual Feed
Phaser 6128MFP Service Manual
Troubleshooting Procedure Table (continued)
Step
Actions and Questions
6
Check No Paper Sensor signal.
Does the voltage between ground
<=>J23-8 on the MCU Board change
when the actuator blocks the
sensor?
The Manual Feed No Paper Sensor did not detect media. This troubleshooting
procedure applies to these errors.
Applicable Errors
•
Load Manual Feed Press OK to continue
•
Remove Paper from manual Feed Press OK to continue
Initial Actions
•
Check the condition of the Manual Feed Detect Sensor actuator.
•
Check manual feed guide adjustment.
•
Check that the media required by the print job is the type/size loaded.
•
Cycle printer power.
•
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Manual No Paper Sensor, PL3.2.13
Manual Feed Actuator, PL3.2.14
Left Side Harness, PL10.4.18
MCU Board, PL10.7.7
Troubleshooting Procedure Table
Step
Actions and Questions
1
Check the Manual Feed Sensor
Actuator for damage or
misalignment. Remove the Lower
Chute (PL3.2.27) to examine the
actuator.
Is the actuator damaged or
misaligned?
Error Messages and Codes
Yes
Replace the
MCU Board
(page 8-57).
Wiring and Plug/Jack Map References
"Map 2 - Feed and Laser Unit" on page 10-7
"Media Feed" on page 10-15
Yes
Repair or
replace the
Manual Feed
Sensor
Actuator
(page 8-28).
No
Replace the
Manual Feed
No Paper
Sensor
(page 8-28).
No
Go to step 2.
3-81