Check Unit Adc Sensor - Xerox Phaser 6000 Service Manual

Check Unit ADC Sensor

Phaser 6000/6010 and WC 6015 MFP
This message indicates that the ADC Sensor needs cleaning.
Applicable Errors
• 092-310: ADC Sensor Dustiness Pre Warning
• 092-910: ADC Sensor Dustiness
Initial Actions
• Cycle printer power.
• Clean the ADC Sensor (page 7-7).
• If the problem persists, use the following procedure.
Troubleshooting Reference Table
Applicable Parts
MCU Board, PL7.2.2
Troubleshooting Procedure Table
Step Actions and Questions
1 Disconnect P/J14 on the MCU
Board.
Is the voltage across ground at
P/J14-1 and P/J14-9 on the MCU
Board +5 VDC?
2 Does the error persist?
Xerox Internal Use Only
Error Messages and Codes
Wiring and Plug/Jack Map References
"Map 3 - Phaser 6000/6010" on
page 10-9
"Phaser 6000/6010 Developer" on
page 10-16
"Map 3 - WorkCentre 6015 MFP" on
page 10-23
"WorkCentre 6015 MFP Developer" on
page 10-30
Yes
Go to step 2.
Contact your
designated
field support for
assistance.
No
Replace the
MCU Board
(page 8-121),
then go to
step 2.
Complete.
3-95