B External Connections
Connecting the Edwards oil-free roughing pump
Warning:
disconnect all power cables from the oil-free roughing pump before
performing maintenance procedures on the pump. Always carry out
maintenance in accordance with the operator's guide supplied with the
roughing pump.
The oil-free roughing pump is an alternative to the oil-filled roughing pump.
To connect the oil-filled roughing pump, see
Required materials
•
Chemical-resistant, powder-free gloves
•
7-mm nut driver
•
Sharp knife
•
NW25 tee (included in the installation kit)
•
NW25 center rings (included in the installation kit)
•
NW25 clamps (included in the installation kit)
•
NW40 center rings (included in the installation kit)
224
March 14, 2014, 715004387 Rev. B
To avoid electric shock, shut down the mass spectrometer, and
Inlet flange
TP03165
page
219.
Exhaust port flange