Replacing The Oil Mist Filter - Waters Xevo TQ MS Operator's, Overview And Maintenance Manual

4 Maintenance Procedures

Replacing the oil mist filter

Required materials
• Chemical-resistant, powder-free gloves
• 3-mm Allen wrench
• New oil mist filter
Warning:
toxic materials, always wear chemical-resistant, powder-free
gloves when performing this procedure. The oil mist filter and
canister components can be contaminated with analyte
accumulated during normal operation.
To replace the oil mist filter:
1. Use the 3-mm Allen wrench to remove the 4 screws securing the oil mist
canister cover to the oil mist canister.
Cover securing screw
Oil mist canister
2. Remove the oil mist canister cover from the oil mist canister.
The cover can be tight and difficult to remove.
Tip:
106 February 11, 2013, 71500130002 Rev. D
To avoid personal contamination with biohazards or