Replacing The Roughing Pump's Oil; Required Materials - Waters Xevo TQD IVD Overview And Maintenance Manual

Table of Contents

Advertisement

2.
Use the 8-mm Allen wrench to unscrew and remove the roughing pump's oil filler plug (see
the figure on
Requirement:
3.
Using the funnel, add Anderol vacuum oil, type LVO200, into the oil filler aperture until the
oil reaches the oil level sight glass MAX level.
4.
Ensure that the O-ring on the oil filler plug is clean and properly seated.
Notice:
the oil filler plug, ensure that
5.
Use the 8-mm Allen wrench to fit and tighten the roughing pump's oil filler plug.
Tips:
When the oil filler plug is tightened, the plug seals by means of an O-ring. Compression
is controlled by the O-ring groove depth in the plug. Overtightening does not improve
the plug seal; it merely makes the plug difficult to remove.
After you add oil to the pump, the following situations can occur:

4.14 Replacing the roughing pump's oil

Change the roughing pump oil annually.
Recommendation: Change the oil filter when replacing the roughing pump oil. See the Sogevac
SV40 BI Pump Manual for details about ordering parts.
See also:
The Sogevac SV40 BI Pump Manual.
Note:
This procedure is not required for an Edwards oil-free roughing pump.
4.14.1

Required materials

Chemical-resistant, powder-free gloves
8-mm Allen wrench
Flat-blade screwdriver
Container to catch used oil
Funnel
page
51).
To maintain pump performance, use only Anderol vacuum oil, type LVO200.
To avoid oil leakage, and consequent damage to the pump, when refitting
the plug is not cross-threaded;
the O-ring is not pinched;
the plug is not overtightened.
The oil level drops slightly during the first month of operation.
The oil darkens in color over time.
After running the pump for 12 to 48 hours, it is common to see a few drops of oil
near the filler plug. Excess oil around the lip of the filler plug will run down and drip
off the pump when the pump reaches operating temperature.
When the pump begins to run at normal operating temperature, the spilled oil
produces a slight odor.
September 7, 2016, 715003560IVD Rev. C
Page 55

Advertisement

Table of Contents
loading

Table of Contents