Huawei IDS2000 Installation Manual page 89

IDS2000 Intelligent Micro-Modular Data Center
Installation Guide (2000 mm High Cabinet in Dual-Row
Aisle Containment)

Properly hold the door closer arm when installing or removing it to prevent it from
bouncing due to the pretightening force from the closer.

Keep unused accessories properly. They may be used when the door status sensor is
installed.
Figure 4-82 Installing a door closer arm
Step 4 Open the door to the maximum and snap the closer lever into the guide rail.
Figure 4-83 Guide rail
(1) Buckle
(2) Tuning screw used to tune the maximum door openness
(3) Spring screw used to fix the door to its current openness



Issue Draft A (2015-06-29)
If the lever does not fit firmly into the guide rail, adjust the captive screws using the solid wrench
delivered with the closer to fasten the lever.
Secure the stop block of the closer to the required position using a flat-head screwdriver based on
the door opening angle, as shown by (2) in
Tighten the screws to ensure that the stop block works properly, as shown by (3) in
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Figure 4-83.
4 Hardware Installation
Figure 4-83.
81