Huawei IDS2000 Installation Manual page 84

IDS2000 Intelligent Micro-Modular Data Center
Installation Guide (2000 mm High Cabinet in Dual-Row
Aisle Containment)
It is recommended that you install hinges from the top to the bottom.
2.
Step 2 Adjust gaps between door panels.
After the door panels are installed and closed, gaps between panels may be uneven and look
ungraceful, as shown in
Table 4-6 Type of fault
Type of Fault
Tilted door panel
Varying gap between
door panel and upper
frame mounting kit
Door mismatch
1.
Issue Draft A (2015-06-29)
Figure 4-74 Securing a door panel to each post using hinges
Secure the door panels to the posts using M4 countersunk screws.
Table
Figure 4-75 shows a tilted door. You can solve the problem in the following ways:
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4-6. If the gaps are even, skip this procedure.
Root Cause
The left and right cabinets
onto which the upper frame
mounting kit is hung are not
on the same level, or the upper
frame mounting kit and posts
are tilted because the floor is
uneven.
One post has tilted, or the door
does not match with the upper
frame mounting kit due to a
manufacturing tolerance.
The left and right cabinets
onto which the upper frame
mounting kit is hung are not
on the same level.
4 Hardware Installation
Measure
For details about the adjusting
method, see Step 2.1.
For details about the adjusting
method, see Step 2.2.
For details about the adjusting
method, see Step 2.3.
76