Setup
Media and Additional Parts
Description
Operator's Manual
Parts catalog
Certification of compliance
Target plate
Weight bar
1
Installing the Front Roller
No Parts Required
Procedure
The cutting unit is shipped without a front roller.
Install the roller using the loose parts supplied with
the cutting unit and installation instructions included
with the roller.
2
Using the Cutting-Unit Prop
No Parts Required
Procedure
Whenever you tip the cutting unit to expose the
bedknife/reel, prop up the rear of the cutting unit
to ensure that the nuts on the back end of the
bedbar-adjusting screws are not resting on the work
surface
(Figure
3).
Qty.
1
Read this before installing and operating cutting unit.
1
Use this to reference part numbers.
1
Save this for future reference.
1
Install these parts if you are using an eFlex traction unit.
1
1. Prop (not provided)
3
Adjusting the Bedknife to
the Reel
No Parts Required
Procedure
Note:
Use this procedure after grinding, backlapping,
or disassembling the reel This is not a daily
adjustment.
Note:
For eFlex cutting units, the reel-to-bedknife
contact has significant impact on energy consumption.
Very light contact is recommended for optimum cutting
performance and minimum battery consumption.
1.
Position the cutting unit on a flat, level work
surface.
2.
Tip the cutting unit to expose the bedknife and
reel.
4
Use
Figure 3
2. Bedknife-adjusting screw
nut (2)
g016943