Adjusting The Reel Speed; Bleeding The Fuel System - Toro Reelmaster 3100-D Operator's Manual

Adjusting the Reel Speed

1. Verify the height-of-cut setting on the cutting
units. Use the column of the Reel Speed
Selection Chart listing either 8-blade or 11-
blade reels, and find the height-of-cut listing
nearest the actual height-of-cut setting. Look
across the chart to find the reel-speed number
that corresponds to that height-of-cut.
2. Lift the cover
3. Turn the reel-speed-control knob
reel-speed number determined in
4. Install the cover on the control arm.
5. Operate the machine for several days, then
examine the cut to ensure the quality-of-cut.
The reel speed knob may be set 1 position on
either side of the reel-speed number indicated
on the chart to account for differences in grass
condition, grass length removed, and personal
preference.

Bleeding the Fuel System

1. Park the machine on a level surface, lower the
cutting units, engage the parking brake, shut
off the engine, and remove the key.
2. Ensure that the fuel tank is at least half full.
3. Unlatch and raise the hood.
4. Open the air-bleed screw
injection pump.
5. Turn the ignition key to the O
Note:
out around the air-bleed screw.
3466-297A
from the control arm.
The electric fuel pump runs, forcing air
G411273
to the
Step 1.
G411274
on the fuel-
position.
N
G411275
Page 5–9 Operation: During Operation