The Grooming Brush (Optional) - Toro Greensmaster e1021 Service Manual

The Grooming Brush (Optional)

Greensmaster ® e1021/e1026
20246SL Rev A
g229629
1. Spiral brush
2. Brush shaft
3. J-bolt (2 each)
The optional grooming brush attaches to the groomer in place of the groomer
reel. The grooming brush is removed and installed from the groomer in the same
manner as the groomer reel; refer to
The grooming brush element or shaft can be serviced separately.
To remove the spiral grooming brush from the shaft, remove the lock nut and
J-bolt from both ends of the brush assembly and slide the brush from the shaft.
When assembling the spiral brush to the shaft, make sure that the J-bolts are
installed with the threaded portion on the outside of the brush and tighten the
lock nuts from 2.3 to 2.8 N∙m (20 to 25 in-lb).
Figure 126
4. Lock nut (2 each)
5. Grooming brush
6. Roll pin (2 each)
The Groomer Reel (page
Page 8–19 Universal Groomer (Optional): Service and Repairs
8–14).