Lift Arm/Lift Lever Assembly; Removal - Toro 400XT Series Service Manual

Lift Arm/Lift Lever Assembly

Removal

1. Remove the right and left side panels. Remove
the center access plate. Disconnect the battery
cables and remove the battery from the tractor.
2. Remove the two bolts holding the battery support
and remove the support (Figure 62).
Figure 62
3. Remove the 4 screws and 2 nuts from the base of
the dash. Remove the bolt and nut located in the
center of the hood stand, just below the large
decal (Figure 63).
Figure 63
400XT Series Tractor Service Manual
4. Pull the dash upwards, with the steering shaft, and
move carefully toward the front of the tractor to
give you enough clearance to get to the lift
assembly (Figure 64).
5. Remove the six bolts, three located on the right
and three on the left side, inside of the hood stand
(Figure 65).
MVC-815F
MVC-817F
CHASSIS
Figure 64
Figure 65
MVC-820F
MVC-821F
2 - 19