Adjust Front Lift Arm Carrier Stop Bracket Assembly - Toro Groundsmaster 3500 30807 Service Manual

Adjust Front Lift Arm Carrier Stop Bracket Assembly

1. Park machine on a level surface, fully raise cutting
units, stop engine, engage parking brake, and remove
key from the ignition switch.
2. Make sure that pivot brackets (items 6 and 9) are not
overtightened. They should pivot and return freely.
3. To allow horizontal movement of the actuators (items
2 and 8), loosen carriage screws and flange nuts that se-
cure actuators to actuator mount brackets.
4. To allow vertical movement of the actuator mount
brackets (item 3), loosen carriage screws and flange
nuts that secure actuator mount brackets to lift arms.
5. Simultaneously move both actuators against back of
the carrier stop bracket and pivot brackets. Secure actu-
ators (items 2 and 8) to actuator mount brackets with
carriage screws and flange nuts.
6. With pivot brackets tipped forward, slide actuator
mount brackets down so that the actuators just contact
the pivot brackets. Secure actuator mount brackets to lift
arms with carriage screws and flange nuts.
Groundsmaster 3500
8
10
9
1. LH lift arm
2. LH actuator
3. Actuator mount bracket
4. Horizontal screw
5. Vertical screw
6. LH pivot bracket
Page 7 - 5
7
3
4
3
5
6
FRONT
11
Figure 7
7. RH lift arm
8. RH actuator
9. RH pivot bracket
10. Carrier stop bracket
11. Return spring
Wheels, Brakes,and Chassis
1
2