Table of Contents
Advertisement
Figure 76
Left Side Shown
1. L-bracket
2. Linkage stop
3. Gap
9.
Disengage the parking brake, the lever should
be in the down position.
10.
Turn the wheel hub by hand in both directions
relative to the caliper; the wheel hub should
move freely between the caliper.
11.
If a gap is needed or the wheel hub does not
move freely:
A.
Disengage the parking brake.
B.
Disconnect and fine-tune the rear linkage
assembly:
•
Shorten the link to create a gap.
•
Lengthen the link to allow wheel hub
movement.
C.
Connect the rear linkage assembly.
12.
Engage the parking brake and check the gap.
13.
Repeat steps
9
through
achieved and the wheel hub rotates freely.
14.
Repeat this procedure for the brake on the
opposite side.
15.
Rotate the drive-wheel release handle to
the operating position; refer to
Drive-Wheel-Release Valves (page
16.
Install the rear tires and torque the lug nuts; refer
to
Checking the Wheel-Lug Nuts (page
17.
Remove the jack stands.
g026961
4. Rear linkage assembly
5. Caliper
6. Wheel hub
13
until a visible gap is
Using the
30).
51).
Belt Maintenance
Inspecting the Belts
Service Interval: Every 50 hours
Replace the belt if it is worn. The signs of a worn belt
include squealing while the belt is rotating; the blades
slipping while cutting grass; and frayed edges, burn
marks, and cracks on the belt.
Replacing the
Counter-Rotating Belt
1.
Disengage the blade-control switch (PTO), move
the motion-control levers to the N
position, and engage the parking brake.
2.
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3.
Lower the mower to the 76 mm (3 inches) height
of cut.
4.
Lift the floor pan up to gain access to the center
pulley.
5.
Remove the plastic belt cover
6.
Remove the 3 bolts holding the metal belt cover
in place and remove the metal belt cover.
1. Idler spring
2. Counter-rotating belt
3. Double pulley
56
EUTRAL
(Figure
78).
Figure 77
4. Idler pulley
5. Square hole for ratchet
-
LOCK
g024145
Advertisement
Table of Contents
