Table of Contents
Advertisement
10. Rotate the locking collar on the harness plug clockwise
until it engages with the battery receptacle and begins
to pull in toward the battery.
Note: Continue turning it another 120 degrees (1/3
of a turn) until it fully seats.
Note: If you cannot mate the battery pack receptacle
with the machine wiring harness plug while the battery
pack is installed, you can instead connect the harness
to the battery pack and then install the battery pack.
Remove the main power supply connector
15) from the battery base. Install the connector to
the battery as described. Install the battery to the
base, threading the attached wiring harness through
the appropriate hole, and then secure the main power
supply connector to the battery base using the fasteners
previously removed.
11. Remove the screwdriver holding the battery base in the
up position, and gently lower the battery platform to
the machine frame.
Important: Do not pinch the wiring harness
between the frame and platform.
12. Secure the battery platform to the machine frame with
the tall nut removed in step 4.
13. Tighten the pivot fasteners loosened in step 5.
14. Route the pack to machine wiring harness under and
behind the main harness on the left side of the machine
and connect the small, 6-pin connector on the harness
to the matching connector on the main wiring harness
as shown in
Figure
1
2
Figure 14
1. Connector on the main
wiring harness
(Figure
14.
G017235
2. Small connector from the
pack to machine wiring
harness
15. Start and turn off the machine to ensure that the
battery will charge completely.
16. Connect the T-handle connector from the main wiring
harness to the main power supply connector on the
battery base
(Figure
G017237
1. T-handle connector
17. Charge the battery as described in the instructions that
came with the battery charger.
Note: The battery is shipped with a partial charge
(approximately 40%). This is enough charge for you to
perform functional checks on the machine and move
it as needed to complete setup, but you should fully
charge the battery before using the machine.
6
Adjusting the EZ-Turn Sensor
No Parts Required
Procedure
1. Ensure that the unit is on a flat, level surface with the
traction drum on the ground.
2. Loosen the jam nuts on the sensor and adjust the
sensor so that 1 thread is visible past the lower jam nut
(Figure
16).
15
15).
2
1
Figure 15
2. Main power supply
connector on the battery
platform
Advertisement
Table of Contents
