Danfoss VLT AutomationDrive FC 360 Programming Manual page 90

Parameter Descriptions
9-64 Device Identification
Range: Function:
NOTICE
0 [0 -
*
0 ]
This parameter is not visible via LCP.
The device identification parameter. The data type is
array [n] of unsigned16. The assignment of the 1
4 4
subindexes is defined and shown in Table 4.9.
Index
0
1
2
3
4
5
6
7
8
9
9-65 Profile Number
Range:
0 [0 - 0 ]
*
9-67 Control Word 1
Range:
0 [0 - 65535 ] This parameter accepts the control word from a
*
9-68 Status Word 1
Range:
0 [0 - 65535 ] This parameter delivers the status word for a
*
88
Content Value
Manufacturer 128
Device type 1
Version xxyy
Firmware date year yyyy
Firmware date ddmm
month
No. of axes Variable
Vendor specific: PB xxyy
Version
Vendor specific: xxyy
Database Version
Vendor specific: xxyy
AOC Version
Vendor specific: xxyy
MOC Version
Table 4.9 Device Identification 1
Assignment
Function:
NOTICE
This parameter is not visible via LCP.
This parameter contains the profile identification.
Byte 1 contains the profile number and byte 2 the
version number of the profile.
Function:
master class 2 in the same format as PCD 1.
Function:
master class 2 in the same format as PCD 2.
Danfoss A/S © 06/2017 All rights reserved.
®
VLT AutomationDrive FC 360
9-70 Edit Set-up
Option:
st
[1] Set-up 1
[2] Set-up 2
[9] Active Set-
*
up
9-71 Profibus Save Data Values
Option:
[0] Off
*
[1] Store all
st
Subindex
setups
9-72 ProfibusDriveReset
Option:
[0] No action
*
[1] Power-on reset
[2] Power-on reset
prep
[3] Comm option
reset
9-75 DO Identification
Range:
0 [0 - 65535 ] Provides information about the DO (drive
*
Function:
Select the set-up in which programming
(change of data) is performed during operation.
It is possible to program the 2 set-ups
independently of the set-up selected as active
set-up. Parameter access from each master is
directed to the set-up selected by the
individual master (cyclic, acyclic MCL1, 1
nd
acyclic MCL2, 2 acyclic MCL2, 3
MCL2).
Function:
Parameter values changed via RS485 are not
automatically stored in a non-volatile memory.
Use this parameter to activate a function that
stores parameter values in the EEPROM non-
volatile memory, so changed parameter values
are retained at power-down.
Deactivates the non-volatile storage function.
Stores all parameter values in the set-up selected
in parameter 9-70 Edit Set-up in the non-volatile
memory. The selection returns to [0] Off when all
values are stored.
Function:
NOTICE
®
Resets the VLT PROFIBUS DP MCA
101 option only.
Resets the frequency converter after
power-up, as for power cycle.
When reset, the frequency converter
disappears from the fieldbus, which may
cause a communication error from the
master.
Function:
object). This parameter is for PROFINET only.
st
rd
acyclic
MG06C702