Parameters: 17-** Feedback Options; Parameters: 18-** Data Readouts - Danfoss VLT AutomationDrive FC 360 Programming Manual

Parameter Descriptions

4.16 Parameters: 17-** Feedback Options

4.16.1 17-1* Inc.Enc.Interface
17-10 Signal Type
Select the incremental type (A/B channel) of the encoder in use.
Find the information on the encoder datasheet.
Option:
4 4
[0]
[1]
*
[2]
17-11 Resolution (PPR)
Range:
1024 [10 - 10000 ] Enter the resolution of the incremental
*
4.16.2 17-5* Resolver Interface
17-50 Poles
Range:
2 [2 - 2 ]
*
17-51 Input Voltage
Range:
7 V
*
17-52 Input Frequency
Range:
10 kHz
*
17-53 Transformation Ratio
Range:
0.5
*
17-56 Encoder Sim. Resolution
Option:
[0]
*
[1]
[2]
[3]
[4]
17-59 Resolver Interface
Option:
[0]
*
[1]
112
Function:
None
RS422 (5V TTL)
Sinusoidal 1Vpp
Function:
track, which is the number of pulses or
periods per revolution.
Function:
Function:
[2 - 8 V]
Function:
[2 - 15 kHz]
Function:
[0.1 - 1.1 ]
Function:
Disabled
512
1024
2048
4096
Function:
Disabled
Enabled
Danfoss A/S © 06/2017 All rights reserved.
®
VLT AutomationDrive FC 360
4.16.3 17-6* Monitoring and App.
17-60 Feedback Direction
Option:
[0]
*
[1]
17-61 Feedback Signal Monitoring
Option:
[0]
[1]
*
[2]
[3]
[4]
[5]
[6]

4.17 Parameters: 18-** Data Readouts 2

4.17.1 18-8* Center Winder Readout
18-81 Tension PID Output
Range:
0 Hz
*
18-82 Center Winder Output
Range:
0 Hz
*
18-83 Line Speed
Range:
0 Hz
*
18-84 Diameter
Range:
0 %
*
18-85 Tapered Tension Set Point
Range:
0 %
*
18-86 Tension Feedback
Range:
0 %
*
Clockwise
Counter clockwise
Disabled
Warning
Trip
Jog
Freeze Output
Max Speed
Switch to Open Loop
Function:
[-5000 - 5000 Hz] Read-only parameter used to show
the output of the tension loop PID.
Function:
[-5000 - 5000 Hz] Read-only parameter used to display
the output of the tension loop PID.
Function:
[-5000 - 5000 Hz] Read-only parameter used to display
the output of the tension loop PID.
Function:
[0 - 100 %] Read-only parameter that is used to display
the diameter of the roll.
Function:
[0 - 100 %] Read-only parameter used to display the
tapered tension set point.
Function:
[0 - 100 %] Read-only parameter used to display the
actual tension feedback.
Function:
Function:
MG06C702