Danfoss VLT AutomationDrive FC 360 Programming Manual page 107

Parameter Descriptions
14-55 Output Filter
Option: Function:
NOTICE
This parameter cannot be changed
while the motor is running.
Select the type of output filter connected.
[0] No Filter
*
[1] Sine-Wave Filter
4.13.7 14-6* Auto Derate
Use this parameter group to configure automatic derating
for the output current of the frequency converter.
14-61 Function at Inverter Overload
When the frequency converter issues a frequency converter
overload warning, select whether to continue and trip the
frequency converter, or derate the output current.
Option:
[0] Trip
*
[1] Derate
14-63 Min Switch Frequency
Option: Function:
Set the minimum switch frequency allowed by
the output filter.
[2] 2.0 kHz
*
[3] 3.0 kHz
[4] 4.0 kHz
[5] 5.0 kHz
[6] 6.0 kHz
[7] 8.0 kHz
[8] 10.0 kHz
[9] 12.0 kHz
[10] 16.0 kHz
14-64 Dead Time Compensation Zero Current Level
Option: Function:
[0] Disabled
*
[1] Enabled If using a long motor cable, select this option to
minimize the motor torque ripple.
14-65 Speed Derate Dead Time Compensation
Range: Function:
Size [ 20 - Deadtime compensation level is reduced
related 1000 Hz] linearly versus output frequency from
*
the maximum level set in
parameter 14-07 Dead Time Compen-
sation Level to a minimum level set in
this parameter.
MG06C702
Programming Guide
4.13.8 14-8* Options
14-89 Option Detection
Selects the behavior when an option change is detected. This
parameter returns to [0] Protect Option Config. after an option
change.
Option:
[0]
[1]
4.13.9 14-9* Fault Settings
Use the parameters to configure the fault settings.
14-90 Fault Level
Function:
Use this parameter to customize fault levels. Use the 8
to control the fault level of alarm 13, Overcurrent.
Option:
[3]
[4]
[5]
Index
0
1
2
3
4
5
6
7
Table 4.10 Table for Selection of Action when
Selected Alarm Appears (Parameter 14-90 Fault Level)
D = Default setting
x = Possible selection
Danfoss A/S © 06/2017 All rights reserved.
Function:
Protect Option Config. Freezes the current settings and
*
prevents unwanted changes when
missing or defective options are
detected.
Enable Option Settings can be changed when the
Change system configuration is being
modified.
Function:
Trip Lock Alarm is set to trip lock.
*
Trip w. Alarm is configured into trip alarm, which
delayed reset can be reset after a delay time. For
example, if alarm 13, Overcurrent is
configured to this option, it can be reset 3
minutes after the alarm.
Flystart At start-up, the frequency converter tries to
catch a spinning motor. If this option is
selected, parameter 1-73 Flying Start is
forced to [1] Enabled.
Alarm Trip lock
Reserved –
Reserved –
Reserved –
Reserved –
Reserved –
Reserved –
Reserved –
Overcurrent D
4
th
element
Trip w. Flystart
delayed
– –
– –
– –
– –
– –
– –
– –
x x
105
4