Danfoss VLT AutomationDrive FC 360 Programming Manual page 19

Programming
Setup 1
OK
1
Setup 1
2 x
2
OK
+
Setup 1
OK 3
Setup 1
4
Setup 1
5
Setup 1
6
Setup 1
7
Setup 1
8
Setup 1
Illustration 3.6 Main Menu Interactions - Continuous
Parameters
MG06C702
Programming Guide
1 [OK]: The first parameter in the group is shown.
2
Press [
12
3 Press [OK] to start editing.
4 [►]: First digit flashing (can be edited).
11
5 [►]: Second digit flashing (can be edited).
6
[►]: Third digit flashing (can be edited).
10
▼
7
[ ]: Decreases the parameter value, the decimal point
changes automatically.
▲
8
[ ]: Increases the parameter value.
9 [Back]: Cancel changes, return to 2.
[OK]: Accept changes, return to 2.
▲
10
[ ][
11 [Back]: Removes the value and shows the parameter group.
▲
12
[ ][
Table 3.5 Changing Values in Continuous Parameters
For enumerated parameters, the interaction is similar, but
the parameter value is shown in brackets because of the
LCP 21 digits limitation (4 large digits), and the enum can
be greater than 99. When the enum value is greater than
99, the LCP 21 can only show the first part of the bracket.
9
OK
1
OK
2
OK
Illustration 3.7 Main Menu Interactions - Enumerated
Parameters
1 [OK]: The first parameter in the group is shown.
2 Press [OK] to start editing.
▲
3
[ ][
4 Press [Back] to cancel changes or [OK] to accept changes
(return to screen 2).
▲
5
[ ][
6 [Back]: Removes the value and shows the parameter group.
▲
7
[ ][
Table 3.6 Changing Values in Enumerated Parameters
Danfoss A/S © 06/2017 All rights reserved.
▼
] repeatedly to move down to the parameter.
▼
]: Select parameter within the group.
▼
]: Select group.
Setup 1
Setup 1
Setup 1
▼
]: Change parameter value (flashing).
▼
]: Select a parameter within the group.
▼
]: Select a group.
3 3
7
6
5
4
OK
3
17