Danfoss VLT AutomationDrive FC 360 Programming Manual page 11

Introduction
1.3.2 Start/Stop
Terminal 18 = Parameter 5-10 Terminal 18 Digital Input [8]
Start.
Terminal 27 = Parameter 5-12 Terminal 27 Digital Input [0]
No operation (Default coast inverse).
12 18 19 27
Start/Stop
Speed
Start
[18]
Illustration 1.6 Start/Stop
MG06C702
Programming Guide
29 31 32 33 20
Danfoss A/S © 06/2017 All rights reserved.
1.3.3 Latched Start/Stop Inverse
Terminal 18 = Parameter 5-10 Terminal 18 Digital Input [9]
Latched start.
Terminal 27 = Parameter 5-12 Terminal 27 Digital Input [6]
Stop inverse.
12 13 18 19
Latched start Stop inverse
Speed
Latched start (18)
Stop inverse (27)
Illustration 1.7 Latched Start/Stop Inverse
27 29 32 33
9
1 1