Danfoss VLT AutomationDrive FC 360 Programming Manual page 34

Parameter Descriptions
0-31 Custom Readout Min Value
Range:
0 CustomRea-
doutUnit
*
4 4
0-32 Custom Readout Max Value
Range:
100 Custom-
ReadoutUnit
*
0-37 Display Text 1
Range:
[0 - 0 ] Free text, for example used for the device tag of
fieldbus application.
0-38 Display Text 2
Range:
[0 - 0 ] Free text, for example used for the location tag of
fieldbus application.
0-39 Display Text 3
Range:
[0 - 0 ] Free text, for example used for the help tag of
fieldbus application.
4.1.5 0-4* LCP Keypad
Enable, disable, and password protect individual keys on
the LCP.
0-40 [Hand on] Key on LCP
Option:
[0] Disabled Avoid accidental start of the frequency converter
[1] Enabled [Hand On] is enabled.
*
0-42 [Auto on] Key on LCP
Option:
[0] Disabled Avoid accidental start of the freqeuncy converter
[1] Enabled [Hand On] is enabled.
*
32
Function:
[ 0 - This parameter sets the
999999.99 minimum value of the custom
CustomRea- readout (occurs at 0 speed). It is
doutUnit] only possible to select a value
different from 0 when selecting a
linear unit in
parameter 0-30 Custom Readout
Unit. For quadratic and cubic
units, the minimum value is 0.
Function:
[ 0.0 - This parameter sets the
999999.99 maximum value to be shown
CustomRea- when the motor speed has
doutUnit] reached the value set in
parameter 4-14 Motor Speed
High Limit [Hz].
Function:
Function:
Function:
Function:
in hand-on mode.
Function:
from LCP.
Danfoss A/S © 06/2017 All rights reserved.
®
VLT AutomationDrive FC 360
0-44 [Off/Reset] Key on LCP
Option:
[0]
[1]
*
[7]
4.1.6 0-5* Copy/Save
Copy parameters from and to NLCP and GLCP. Use these
parameters for saving and copying set-ups from 1
frequency converter to another.
0-50 LCP Copy
Option:
[0] No copy
*
[1] All to LCP
[2] All from
LCP
[3] Size indep.
from LCP
0-51 Set-up Copy
Option:
[0] No copy
*
[1] Copy from
setup 1
[2] Copy from
setup 2
[9] Copy from
Factory setup
4.1.7 0-6* Password
0-60 Main Menu Password
Range:
0 [0 - 999 ] Define the password for access to the Main Menu
*
Disabled
Enabled
Enable Reset Only
Function:
No function.
Copy all parameters in all set-ups from the
frequency converter memory to the LCP. For
service purposes, copy all parameters to the
LCP after commissioning.
Copy all parameters in all set-ups from the LCP
memory to the frequency converter memory.
Copy only the parameters that are
independent of the motor size. This selection
can be used to program several frequency
converters with the same function without
disturbing motor data that is already set.
Function:
No function.
Copy from set-up 1 to set-up 2.
Copy from set-up 2 to set-up 1.
Copy factory setting to programming set-
up (selected in parameter 0-11 Programming
Set-up).
Function:
via the [Main Menu] key. Setting values to 0
disables the password function.
Function:
MG06C702