Danfoss VLT AutomationDrive FC 360 Programming Manual page 85

Parameter Descriptions
4.9.6 8-7* Protocol SW Version
8-79 Protocol Firmware version
Range: Function:
Size related [0 - 65535 ] Firmware revision: FC is in index 0;
*
Modbus is in index 1; indexes 2–4
are reserved.
4.9.7 8-8* FC Port Diagnostics
These parameters are used for monitoring the bus
communication via the frequency converter port.
8-80 Bus Message Count
Range: Function:
0 [0 - 4294967295 ] This parameter shows the number of
*
valid telegrams detected on the bus.
8-81 Bus Error Count
Range: Function:
0 [0 - 4294967295 ] This parameter shows the number of
*
telegrams with faults (for example CRC
faults) detected on the bus.
8-82 Slave Messages Rcvd
Range: Function:
0 [0 - 4294967295 ] This parameter shows the number of
*
valid telegrams sent by the frequency
converter to the slave.
8-83 Slave Error Count
Range: Function:
0 [0 - 4294967295 ] This parameter shows the number of
*
error telegrams, which could not be
executed by the frequency converter.
8-84 Slave Messages Sent
Range: Function:
0 [0 - 4294967295 ] This parameter shows the number of
*
messages sent from the slave.
8-85 Slave Timeout Errors
Range: Function:
0 [0 - 4294967295 ] This parameter shows the number of
*
slave timeout errors.
8-88 Reset FC port Diagnostics
Option: Function:
[0] Do not reset Do not reset all FC port diagnostic counters.
*
[1] Reset counter Reset all FC port diagnostic counters.
MG06C702
Programming Guide
4.9.8 8-9* Bus Feedback
Use the parameter group to configure the bus feedback.
8-90 Bus Jog 1 Speed
Range:
100 RPM
8-91 Bus Jog 2 Speed
Range:
200 RPM
Danfoss A/S © 06/2017 All rights reserved.
Function:
[ 0 - 1500 Enter the jog speed. This is a fixed
*
RPM] jog speed activated via the serial
port or fieldbus option.
Function:
[ 0 - 1500 Enter the jog speed. This value is a
*
RPM] fixed jog speed activated via the
serial port or fieldbus option.
4 4
83