Configure The System Software; Monitoring Leds; Power Led - Waters ACQUITY UPLC M-Class System Manual

3 Preparing the System
• TVM
• Sample organizer, if present
3. When the power LEDs on all solvent managers and on the μSM-FL show
as steady green, press the power switch on the top, left-hand side of the
detector (or detectors).
Important:
detectors) only when the flow cell is wetted.

Configure the system software

To configure the system software:
1. Ensure the latest version of MassLynx software is installed on the
workstation.
See also:
MassLynx Getting Started Guide, located on your documentation CD.
For software change note (SCN) details, see the associated release notes,
on the Waters web site, for the appropriate SCN.
2. Install the ACQUITY UPLC M-Class Driver Pack, update your module
firmware, and configure your inlet and system modules.
See also:
Installation and Configuration Guide, on the software media CD for
successful installation of the driver pack. For complete details about
supported firmware, software, and operating systems, see the ACQUITY
UPLC M-Class Driver Pack Release Notes.

Monitoring LEDs

LEDs on each system module indicate its state of functioning. The LEDs are
specific to their modules, so the significance of their various colors and modes
can differ from one module to another.
You can monitor the instrument console for messages and LED
Tip:
indications.

Power LED

The power LED, on the left-hand side of a system module's front panel,
indicates its power-on or power-off status.
32 March 10, 2014, 715003588 Rev. A
To prevent initialization errors, power-on the detector (or
For MassLynx installation or upgrade information, see the
You must refer to the ACQUITY UPLC M-Class Driver Pack