Calling The Created User Cycle - Siemens SINUMERIK 808D ADVANCED Commissioning Manual
Hide thumbs
Also See for SINUMERIK 808D ADVANCED:
- Diagnostic manual (566 pages) ,
- Parameter manual (524 pages) ,
- Operating instructions manual (498 pages)
Table of Contents
Advertisement
13.4.8
Calling the created user cycle
After you transfer all the files necessary for your own cycle to the control system, the cycle is created successfully. Then you
can call the cycle in the program editing operating area.
Proceed as follows to call the created cycle, for example, CYCLE100.
284
4.
Find the folder for storing the extended user text file through the following operations, and
press this key to open it:
5.
Press this softkey to paste the extended user text file.
6.
Press this softkey when a message appears prompting you to restart the HMI. The new
data will be active after the HMI restarts successfully.
1.
Select the program management operating area.
2.
Select the desired part program and press this key to open it in the program editor.
Then you can see the softkey you define at the fifth horizontal softkey, for example:
→
→
Commissioning Manual
01/2017
Advertisement
Table of Contents
