Calling The Cycle; Parameter - Siemens SINUMERIK 840D sl Operating Manual

3. Subprogram
The contour is located in a subprogram in the same workpiece.
4. Labels in the subprogram
The contour is in a subprogram and is limited by the labels that have been entered.
9.1.5.2

Calling the cycle

Procedure
9.1.5.3

Parameter

Parameter
Contour selection
Contour name
Labels
Subprogram
Labels in the subpro‐
gram
Note
Calling via EXTCALL
Calling a part program via EXTCALL without EES: via "contour name" or "labels." This behavior
is monitored in the cycle.
Contour calls via "subprogram" or "labels in subprogram" are only possible if EES is active.
Grinding
Operating Manual, 05/2017, A5E40869190
1. The part program to be executed has been created and you are in the
editor.
2. Press the "Contour" and "Contour call" softkeys.
The "Contour Call" input window opens.
3. Assign parameters to the contour selection.
Description
● Contour name
● Labels
● Subprogram
● Labels in the subprogram
CON: Contour name
● LAB1: Label 1
● LAB2: Label 2
PRG: Subprogram
● PRG: Subprogram
● LAB1: Label 1
● LAB2: Label 2
Programming technology functions
9.1 Programming contours
Unit
211