Install Attendant Console - Optional; Install 26B1 Selector Console - Optional - Avaya DEFINITY ONE Installation And Upgrades

Installation and Upgrades for DEFINITY ONE and
IP600 Internet Protocol Release 10 555-233-109
1 Install and Cable the Cabinet
Install and wire telephones and other equipment
Install Attendant Console — optional
To install the optional AC:
1. Position the Attendant Console in the desired location and connect the
modular cord to the information outlet.
2. Install labels per the Attendant Console form and Display Module form
assignments.
3. Install a digital line circuit (DLC) pack in the assigned carrier slot (if
required).
4. Administer the console forms in DEFINITY Enterprise Communications
Server Release 9 Administrator's Guide (555-233-506).
Hard-wire bridging
!
WARNING:
Bridging or paralleling these endpoints can cause electrical damage to the
consoles or cause the circuit pack to remove power from the consoles.
Analog type hard-wire bridging is not allowed for 4-wire (only) DCP endpoints,
because hard-wire bridging provides no way of combining the digital output of 2
bridged DCP sets. Also, a bridged endpoint causes the added load to degrade the
DCP signal.
Dual wiring of 2-wire and 4-wire endpoints
Do not simultaneously wire a 2-wire and 4-wire endpoint to the same equipment
location in an MDF, even though they connect to different colored wire pairs. The
system uses separate circuit packs to interface 2- and 4-wire endpoints, and none
are capable of interfacing both.
Install 26B1 Selector Console — optional
To install the optional Selector Console:
1. Connect the supplied 3-foot (0.9 m) D8AC cable to the modular jack on the
bottom of the 26B1 Selector Console.
2. Route the cable to the Attendant Console and connect to the DXS/BLF
jack.
3. Attach labels according to the Attendant Console form.
4. Administer the Attendant Console using DEFINITY Enterprise
Communications Server Release 10 Administrator's Guide (555-233-506).
Issue 6
December 2001
1-109