Avaya DEFINITY ONE Installation And Upgrades page 72

Installation and Upgrades for DEFINITY ONE and
IP600 Internet Protocol Release 10 555-233-109
1 Install and Cable the Cabinet
Cable the Avaya IP600 system
5. Pull open the EMI Gasket, and pass the TDM/LAN bus cable through the
routing slots in both cabinets. Push the free end of the EMI Gasket back in
place. See
!
6. Install the lower terminator of the TDM/LAN bus cable on right end of
TDM/LAN bus in Cabinet A.
7. Install the upper terminator of the TDM/LAN bus cable on the right end of
the TDM/LAN bus Cabinet B.
8. Flip over the routing slot plates and reinstall both. Once the plates are
reinstalled, the ends of the routing slots are covered.
9. Reinstall the fan assemblies and bottom panel.
Figure 1-16 on page
WARNING:
Make sure the arrows on the back of the cable terminators point
upward.
1-33.
Issue 6
December 2001
1-32