Rack-Mount The Avaya Ip600 Cabinet - Avaya DEFINITY ONE Installation And Upgrades

Installation and Upgrades for DEFINITY ONE and
IP600 Internet Protocol Release 10 555-233-109
1 Install and Cable the Cabinet
Install the Avaya IP600 system cabinet

Rack-mount the Avaya IP600 cabinet

!
WARNING:
Make sure the standard 19" rack supplied by the customer is properly
installed and solidly secured to the floor. If the rack is not secured to the
floor, do not proceed with installation.
1. Make sure the door has been removed.
2. Remove all circuit packs and the power supply.
!
WARNING:
When handling circuit packs or any components of the Avaya IP600, always
wear an authorized wrist ground strap connected the ground connector
provided on the system cabinet. Store circuit packs during cabinet
installation such that they will not be damaged by electrostatic discharge.
3. If necessary, prepare the RMC for mounting in the medial position by
removing the screws on the mounting brackets, moving the brackets to a
position midway on the cabinet, and installing the screws through the
mounting bracket and into the cabinet holes.
4. Using the Rack Mounting Guide, locate a set of rack holes to be used for
mounting. Note the position of the upper key-hole shaped slots on each
rail.
!
5. Insert two mounting screws into the left and right rails of the rack in the
holes noted in step 4. Leave enough space between the screw head and
the rail surface to accept the mounting bracket. See
1-15.
6. Lift the empty RMC and slide the key-hole slots on the mounting brackets
onto the two mounting screws.
!
NOTE:
19" mounting screw holes are not evenly spaced. Make sure the
holes selected for mounting the RMC are such that the rack holes
match the all mounting bracket slots on the Guide. See
page 1-15.
WARNING:
Installing the top RMC higher than shoulder level on the rack is not
recommended.
DANGER:
Use lifting precautions! An empty Avaya IP600 RMC weighs
15.8-17.6 kg (35-39 lbs).
Issue 6
December 2001
1-14
Figure 1-6 on
Figure 1-6 on page