System Initialization - Avaya DEFINITY ONE Installation And Upgrades

Installation and Upgrades for DEFINITY ONE and
IP600 Internet Protocol Release 10 555-233-109
3

System Initialization

System Initialization
This chapter describes the procedures needed to initialize the DEFINITY ONE
and IP600 systems.
Starting with Release 10 for DEFINITY ONE and IP600, telephony features are
activated or deactivated by the license file. The System Parameters Customer
Options form is no longer used to activate/deactivate features -- you can still
display this form to see which features are activated but you cannot use it to turn
features on and off.
This chapter is organized as follows:
''Configure DHCP and TFTP Servers'' on page 3-2
''Power up and observe LEDs'' on page 3-4
''Connect the laptop computer to DEFINITY ONE or IP600'' on page 3-4
''Start a Telnet session'' on page 3-4
''Verify the software version number'' on page 3-5
''Determine the serial number'' on page 3-5
''Obtain a password file'' on page 3-6
''License File Overview'' on page 3-14
''Obtain a License File'' on page 3-15
''Resolve alarms'' on page 3-19
''Check system status'' on page 3-19
''Place a test call'' on page 3-19
''Enable customer logins'' on page 3-20
''Administer DEFINITY ONE or IP600'' on page 3-20
''Set Up Call Accounting'' on page 3-34
''Administer DEFINITY for Intuity AUDIX initialization'' on page 3-37
''Intuity AUDIX administration'' on page 3-48
''Download Message Manager and Avaya Site Administration'' on page
3-51
''Administer SNMP'' on page 3-56
''Schedule backups'' on page 3-61
Issue 6
December 2001
3-1