Copy The Firmware Image To Target Port Board - Avaya DEFINITY ONE Installation And Upgrades

Installation and Upgrades for DEFINITY ONE and
IP600 Internet Protocol Release 10 555-233-109
6 Hardware Additions
Downloading Firmware to Port Circuit Packs
Using a GUI-based FTP program
NOTE:
Ping the source board first to verify a communication link to the source
board.
1. Open the FTP program.
2. Type in the source board's IP address and the user ID and password in the
appropriate fields. The user ID and password are the ones you created at
the time you created the filesystem.
3. Select binary for the file type.
4. Press Connect.
5. When connected, select the root directory on the source board (remote).
6. Go to the temporary file directory on your PC (local) that has the
downloadable binary files.
7. Download all the files to the appropriate directory on the source board.
8. Refresh the remote directory, if necessary, to verify that all the files were
transferred.
9. When done, end the FTP session.

Copy the firmware image to target port board

You can download the files immediately or schedule them for download at a less
busy time to minimize down time. This procedure assumes that the firmware
image files are resident on the source board (TN799DP C-LAN).
Make sure the target boards are working before the download.
NOTE:
If you are scheduling circuit packs used as primary and secondary sync
sources (such as TN464GPs), the timing automatically moves to a local
sync source when the boards are busied out during the download. The
timing automatically moves back to the proper sync sources after the boards
are returned to service.
Complete the following tasks:
Check SPE
Locate Target Boards
Verify Trunk Status (optional)
Verify Files
Schedule Download
Check Specified Resources
Monitor Download Progress
Disable Filesystem
Issue 6
December 2001
6-13