Install Off-Premises Station Wiring - Avaya DEFINITY ONE Installation And Upgrades

Installation and Upgrades for DEFINITY ONE and
IP600 Internet Protocol Release 10 555-233-109
1 Install and Cable the Cabinet

Install off-premises station wiring

Install off-premises station wiring
The local telephone company provides the cabling for off-premises stations.
These stations can appear on any of the RJ21X network interfaces provided for
the CO trunks.
!
WARNING:
Use only an FCC-approved (or equivalent) analog type telephone (such as a
2500-type) as an off-premises station. The TN746B and TN2183 Analog
Line circuit packs can be connected to off-premises stations.
1. Install an A25D cable between the RJ21X network interface and a sneak
fuse panel.
2. At the MDF, connect jumper wires between 1 row/connecting block in the
green field and up to 3 rows/connecting blocks in the purple field to
concentrate the analog line pairs.
3. Connect an A25D cable between the sneak fuse panel and the terminal
block connector associated with the green row in Step 2.
4. Install a green label on the terminal block to identify the remote location.
5. Administer per DEFINITY Enterprise Communications Server Release 10
Administrator's Guide (555-233-506).
Install off-premises or out-of-building stations
Out-of-building campus stations are telephones not physically located in the same
building as the equipment room yet located on the same property.
Analog off-premises stations
Figure 1-62 on page 1-121
telephones. Only analog telephones connected to TN742, TN746B, TN2183, or
TN769 Analog Line circuit packs can be installed out-of-building.
The maximum distance from the system cabinet to the out-of-building voice
terminal is 6000 feet (1828.8 meters) using 24 AWG (0.26 mm
shows the connections for 1 to 8 off-premises analog
Issue 6
December 2001
1-120
2
) wire.