Circuit Pack Installation - Avaya DEFINITY ONE Installation And Upgrades

Installation and Upgrades for DEFINITY ONE and
IP600 Internet Protocol Release 10 555-233-109
1 Install and Cable the Cabinet
Install equipment room hardware for DEFINITY ONE
Table 1-10. Non-Allowable Circuit packs and Circuit Modules — Continued
Apparatus
code
TN2301
TN2306
TN2308

Circuit pack installation

!
WARNING:
When handling circuit packs or any components of a DEFINITY ONE,
always wear an authorized wrist ground strap. Connect the strap to the
ground connector provided on the system cabinet.
NOTE:
All of the circuit pack slots in the CMC are "universal slots." Any slot can
contain any type of port circuit pack.
Circuit pack slot loading
All of the circuit pack slots in the CMC are "universal slots." Any slot can contain
any type of port circuit pack with the following exceptions for cabinet A.
1. Install the TN2314 Processor circuit pack in slot 2 of the cabinet. See
Figure 1-41 on page
2. A TN744E Call Classifier/Tone Detector circuit pack is required. The
TN744E should be installed in slot 3.
3. Load all port circuit packs. See
recommended circuit pack layout.
Name
Survivable Remote Logic Switch
ATM Interface (Single-Mode)
Direct Inward Dialing Trunk
1-86.
Table 1-11 on page 1-87
Issue 6
December 2001
1-85
Allowable
No
No
No
for the