7 Maintenance
7.16 Axles/traveling drive
Description of traveling drive
The axial-piston variable displacement motor of the
machine travel hydraulics is installed on the transfer
gearbox. The transfer gearbox is connected to the rear
axle of the machine. The front axle is driven via the
cardan shaft. The wheels are driven via two reduction
gears on each axle.
The axle (differential, axle tubes) shares a common oil
supply. The transfer gearbox and wheel reduction gears
have their own oil supply.
The oil level can be checked on the differential housing
and on the wheel reduction gears!
Information
Check plugs are located in the same positions on the front
and rear axles.
Perform maintenance on the gearbox and axles according
to the inspection intervals specified in this Operator's
Manual.
7-64
Maintenance
Checking the axle oil level
1. Park the machine on firm, level and dry ground.
2. Apply the parking brake.
3. Fully lower the loading frame to the ground.
4. Stop the engine.
5. Raise the wheels at the reduction gears with a jack
and turn them as shown in
6. Unscrew hexagon socket screws a and b
and c
➥ The gearbox oil must be up to the bottom edge of
7. Add gearbox oil if necessary.
8. Screw Allen screws a, b and c back in again.
Fig.
(Fig.
164).
the filler opening.
BA TH412 * 06/2017 * 4512_7-16_Achsen_en.fm
164.
(Fig.
163)
Need help?
Do you have a question about the Telehandler TH412 and is the answer not in the manual?
Questions and answers