Configuring Data Sets; Data Sets - Overview - Siemens SINUMERIK 828D Commissioning Manual

Hide thumbs Also See for SINUMERIK 828D:

Table of Contents

Configuring data sets

The particular drives must have been already commissioned.

The data sets are configured in the "Commissioning" → Drive system" → "Drives" → "Data sets"

operating area. The following prompts lead you through the sequences:

● "Add data set"

● "Remove data set" if an additional data set has already been created

● "Modify data set"

Number of configurable data sets:

● Motor data set → MDS0...3 (max. 4)

● Drive data set → DDS0...31 (max. 8 per MDS)

● Encoder data sets → EDS0...2 (max. 3)

Drive parameters that affect data sets

Default setting p2038 = 0 for Interface Mode: SINAMICS

When a message frame is selected via p0922, the p2038 parameter affects the device-

specific assignment of the bits in the control and status words.

p0922 = 100 ... 199 sets p2038 = 1 automatically and blocks the changing of p2038. This

sets permanently the "SIMODRIVE 611U" Interface Mode with eight DDS per MDS for

these message frames.

The Data Set Assistant (DSA) offers machine manufacturers (OEM) with a simple and efficient

solution for duplicating and modifying data in order to configure the behavior of drives, motors

and encoders. The reuse of the DSA data helps to minimize the configuration effort required

to generate the machine data for matching the various parts.

Motor Data Sets (MDS), Drive Data Sets (DDS) and Encoder Data Sets (EDS) are used to

configure the component characteristics of the drive system. The reuse of data reduces the

configuration levels required for matching the machine dynamics of the individual parts.

CNC commissioning

Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3

Commissioning the drive

5.6 Configuring data sets

Show Quick Links

Table of Contents