Siemens SINUMERIK 828D Commissioning Manual page 594

Tool management
9.1 Machine data for tool management
Dependencies
The setting data SD54215 $TM_FUNCTION_MASK_SET and the machine data MD20360
$TOOL_PARAMETER_DEF_MASK have the following dependencies:
Dependency
SD54215 ⇔ MD20360
Bit 9 ⇔ Bit 0
Bit 8 ⇔ Bit 1
Bit 0 ⇔ Bit 11
Bit 0 ⇔ Bit 12
Enabling the graphic tool and magazine display function
Make the following settings when the tools and the magazine should be represented
graphically:
MD52271 $MCS_TM_MAG_PLACE_DISTANCE
> 0
= 0
You must make the following settings on the user interface:
1. Press the "Settings" softkey in the "Tool list" window.
The "Settings" window opens.
2. Activate the "Switch on graphical magazine display" checkbox.
This checkbox is offered only when the MD52271 $MCS_TM_MAG_PLACE_DISTANCE
machine data has a value > 0.
226
Description
If bit 0 is set in MD20360, then SD54215
bit 9 has no effect because the NC already
returns the linear wear value of the trans‐
verse axis as a diameter value.
If bit 1 is set in MD20360, then SD54215
bit 8 has no effect because the NC already
returns the linear geometry value of the
transverse axis as a diameter value.
If bit 11 is set in MD20360, then SD54215
bit 0 has no effect with regard to cutting
edge parameter 6 (tool nose radius) be‐
cause the NC already returns the tool nose
radius as a diameter value.
If bit 12 is set in MD20360, then SD54215
bit 0 has no effect with regard to cutting
edge parameter 15 (wear radius) because
the NC already returns the wear radius as
a diameter value.
The tools and magazine locations are displayed graphically.
The tools and magazine locations are not displayed graphically.
Recommendation
It is recommended that the setting MD20360
bit 0 and bit 1 not be used.
Instead, use SD4215 bit 9 and bit 8.
MD20360 bit 0 and bit 1 are effective only for
turning and grinding tools. This setting there‐
fore cannot be used on a turning/milling ma‐
chine because the linear component of the
transverse axis applies for turning tools in the
diameter and for milling tools in the radius.
When the setting data is used, only the display
goes to diameter, the internal value in the NC
remains at radius.
It is recommended that the setting MD20360
bit 11 and bit 12 not be used.
Instead, set bit 0 in SD54215.
MD20360 bit 11 and bit 12 apply to all tool
types, i.e. also to turning tools. This setting
therefore cannot be used on a turning/milling
machine because the tool nose radius of a
turning tool should never be specified in the
diameter.
When the setting data is used, only the display
goes to diameter, the internal value in the NC
remains at radius.
Distance between individual magazine lo‐
cations in the unit of measurement of the
basic NC system.
Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3
SINUMERIK Operate