Tuning; Control Response - Siemens SINUMERIK 828D Commissioning Manual

Tuning

6.1

Control response

Function overview
Use the "Automatic servo tuning" function to tune the current, speed and position control loop
with feedforward control. The objective is the fine setting of an axis or spindle using
SINUMERIK Operate:
● Performing frequency response measurements
● Calculation of the speed control loop
● Setting of current setpoint filters
● Calculation of the position control loop
● Validation of the actual behavior of the control loops
● Feedforward control type: Equivalent speed control time
● Path interpolation
Closed-loop control
The controlled system involves three cascaded control loops:
● Current control loop
● Speed control loop
● Position control loop
Figure 6-1
Each of the individual control loops is tuned successively starting with the current controller,
the speed controller and finally the position controller. The dynamic machine limits for velocity,
acceleration and jerk are set in the interpolator. Whereas the speed control loop is always
CNC commissioning
Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3
Controlled system
6
167