Siemens SINUMERIK 828D Commissioning Manual page 603

direction holder angle" for this tool do not match, then a red cross is displayed for locked. The
yellow triangle for the conflict cannot be seen.
Entries
ShowSymbolActivePlace
ShowSymbolActiveMultiToolPlace
ShowSymbolLoadPlace
ShowSymbolChangeInSpindlePlace
ShowSymbolActiveTool
ShowSymbolProgrammedTool
ShowSymbolActiveDNo
ShowSymbolActiveDNoInTool
ShowSymbolAcitveDlNo
ShowConflictPositionAndDirection
ShowConflictActiveToolWarning
Example
<SETTINGS>
SINUMERIK Operate
Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3
<ReactivateWithMagPos value="false" type="bool" />
<MagazineMoveMessage value="false" type="bool" />
<CreateNewToolDialog value="true" type="bool" />
<MagazineSelectionDialog value="false" type="bool" />
9.2 Configuring the user interface
Meaning
Marking of the magazine location at the machining position.
True - default setting applies for the "Turret" magazine type.
False - setting for all other magazine types.
Marking of the multitool location at the machining position. Is
only displayed when the multitool is located in the spindle or
the tool holder.
True - default setting.
Selection of the magazine location at the loading position.
True - default setting applies for all magazine types (except
Turret is true).
False - setting for the "Turret" magazine type.
Marking of the magazine location at the change position.
True - default setting applies for all magazine types (except
Revolver is true).
False - setting for the "Turret" magazine type.
Marking of the active tool.
False - default setting.
Marking of the follow-on tool.
True - default setting.
Marking of the active cutting edge.
False - default setting.
Marking of the active tool by marking the active cutting edge.
True - default setting for configuration without magazine
management.
False - setting for configuration with magazine management.
Marking of the active DL number.
True - default setting.
Marking of a conflict; tool position and cutting direction do not
match.
True - default setting.
Marking of a conflict; turret magazine type and the active tool
are not at the the machining position.
True - default setting.
Tool management
235