Definition And Functions For Start Softkeys; Defining The Start Softkey - Siemens SINUMERIK 828D Commissioning Manual

Fundamentals

3.3 Definition and functions for start softkeys

You can use the <RECALL> key to close new user interfaces if you have not configured this
key for any other task.
Note
Calling dialogs in the PLC user program
Dialogs can be selected from the PLC as well as via softkeys: An interface signal is available
in DB19.DBB10 for signal exchange between the PLC → HMI.
3.3 Definition and functions for start softkeys
3.3.1

Defining the start softkey

Dialog-independent softkey
Start softkeys are dialog-independent softkeys which are not called from a dialog, but which
have been configured before the first new dialog. In order to access the start dialog or a start
softkey menu, the start softkey must be defined.
Programming
The definition block for a start softkey is structured as follows:
//S(Start)
HS1=(...)
PRESS(HS1)
LM...
END_PRESS
//END
Permissible positions for start softkeys
The following positions for "Run MyScreens" start softkeys are permissible in the operating
areas:
Operating area
Machine
Parameter
Program
Program manager
28
; Start identifier of start softkey
; Define the start softkey: Horizontal SK 1
; Method
; LM or LS function
; End of method
; End identifier of start softkey
Position
HSK6
HSK7
HSK6 and HSK15
Measuring cycles: HSK13 and HSK14
HSK2-8 and HSK12-16, if not assigned to drives.
SINUMERIK Integrate Run MyScreens
Programming Manual, 10/2015, 6FC5397-3DP40-5BA3