Siemens SINUMERIK 828D Commissioning Manual page 469

MD20050 $MC_AXCONF_GEOAX_ASSIGN_TAB[ ]
[0] = 1
[1] = 2
[2] = 3
MD20060 $MC_AXCONF_GEOAX_NAME_TAB[ ]
[0] = X
[1] = Y
[2] = Z
MD20070 $MC_AXCONF_MACHAX_USED[ ]
[0] = 1
[1] = 2
[2] = 3
[3] = 4
[4] = 5
[5] = 6
MD20080 $MC_AXCONF_CHANAX_NAME_TAB[ ]
[0] = X1
[1] = Y1
[2] = Z1
[3] = SP
[4] = A
[5] = C
Preparation for TRACYL
MD24200 $MC_TRAFO_TYPE_2[ ]
= 513
MD24210 $MC_TRAFO_AXES_IN_2[ ]
[0] = 3
[1] = 6
[2] = 2
[3] = 1
SINUMERIK Operate
Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3
X is channel axis 1 if TRACYL is not active
Y is channel axis 2 if TRACYL is not active
Z is channel axis 3 if TRACYL is not active
Geometry axis 1
Geometry axis 2
Geometry axis 3
X as machine axis 1
Y as machine axis 2
Z as machine axis 3
SP1 as machine axis 4
A as machine axis 5
C as machine axis 6
Channel axis name
Channel axis name
Channel axis name
Channel axis name
Channel axis name
Channel axis name
Transformation TRACYL with groove wall offset
Channel axis radial to rotary axis
Channel axis in cylinder surface (rotary axis)
Channel axis parallel to rotary axis
Channel axis special axis to index [0]
Configuring cycles
Assignment of geometry axis to chan‐
nel axis
Geometry axis name in the channel
Machine axis number valid in channel
Name of channel axis in the channel
Definition of 2nd transformation in channel
Axis assignment for transformation 2
7.4 Milling
101