Siemens SINUMERIK 828D Commissioning Manual page 609

Identifier
ToolInMagInPlace
ToolMonTCW
ToolMonTC
ToolPlaceSpec
ToolPlaceSpecIdent
ToolSearch
ToolMyMag
ToolMyPlace
ToolSizeLeft
ToolSizeRight
ToolSizeUpper
ToolSizeDown
ToolOverSize
ToolState
ToolStateActiv
ToolStateEnabled
ToolStateLocked
ToolStateLockedRO
ToolStateMeasured
ToolStatePrewarn
ToolStatePrewarnRO
ToolStateInChange
ToolStateFixed
ToolStateUsed
ToolStateAutoReturn
ToolStateIgnoreLocked
ToolStateMarkedToUnload
ToolStateMarkedToLoad
ToolStatePermanent
ToolState1To1Exchange
ToolStateHandTool
ToolProtAreaFile
ToolMaxVelo
SINUMERIK Operate
Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3
Parameter or property
Magazine number/Magazine location
Type of tool monitoring, tool life, workpiece
count and wear. If wear monitoring has not been
enabled via the machine data, this parameter is
handled like ToolMonTC.
Type of tool monitoring, tool life and workpiece
count
Location type
Location type, if it is to be displayed as text. The
precondition is that the text for the location type
was configured.
Tool search type for replacement tools
Owner magazine of the tool
Owner magazine location of the tool
Tool size left in half locations
Tool size right in half locations
Tool size upper in half locations
Tool size lower in half locations
Tool size as fixed setting - two half locations left,
two half locations right, one half location top,
one half location bottom
Tool status in the hexadecimal notation
Tool status - tool active
Tool status - tool released
Tool status - tool locked
Tool status - tool locked, only read access
Tool status - tool measured
Tool status - tool has reached prewarning limit
Tool status - tool has reached prewarning limit,
only read access
Tool status - tool is being changed
Tool status - tool fixed place coded
Tool status - tool was in use
Tool status - automatic return
Tool status - do not observe locked
Tool status - tool is marked to unload
Tool status - tool is marked to load
Tool status - tool is permanent
Tool status - one to one replacement
Tool status - manual tool
File name of the tool description which is re‐
quired to define the protection zone
Maximum speed
Tool management
9.2 Configuring the user interface
System variable
$A_TOOLMN /
$A_TOOL_MLN
$TC_TP9
$TC_TP9
$TC_TP7
$TC_TP7
$TC_TP10
$A_MYMN
$A_MYMLN
$TC_TP3
$TC_TP4
$TC_TP5
$TC_TP6
$TC_TP3 -
$TC_TP6
$TC_TP8
$TC_TP8, Bit0
$TC_TP8, Bit1
$TC_TP8, Bit2
$TC_TP8, Bit2
$TC_TP8, Bit3
$TC_TP8, Bit4
$TC_TP8, Bit4
$TC_TP8, Bit5
$TC_TP8, Bit6
$TC_TP8, Bit7
$TC_TP8
$TC_TP8, Bit9
$TC_TP8, Bit10
$TC_TP8, Bit11
$TC_TP8, Bit12
$TC_TP8, Bit14
$TC_TP8, Bit15
$TC_TP_PROTA
$TC_TP_MAX_
VELO
*)
241