Turning; General; Setting Up Cycles For Turning - Siemens SINUMERIK 828D Commissioning Manual

ENDIF
;
;––––––––––––––––––––––––––––––––––––
_NV=_NPV+_ACT ; Calculate current zero offset
N10 G[8]=_NV ; There must not be a calculation here
RET
7.5

Turning

7.5.1

General

All settings for machine and setting data of the standard cycles are also applicable for milling
under ShopMill and turning under ShopTurn.
7.5.2

Setting up cycles for turning

Setting the coordinate system
MD52000 $MCS_DISP_COORDINATE_SYSTEM
= 0
Examples:
0: Vertical turning machine (carousel-type turning machine)
19: Horizontal turning machine, machining in front of the turning center
34: Horizontal turning machine, machining behind the turning center (inclined bed turning
machine)
A detailed description of MD52000 is given in Section: "Activating turning/milling/drilling/
grinding technologies (Page 75)."
Turning function screen
Enable various functions under the Turning function screen in the following channel-specific
configuration machine data.
MD52218 $MCS_FUNCTION_MASK_TURN
Bit 0
Bit 1
Bit 2
Bit 3
SINUMERIK Operate
Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3
Default setting
Enable zoom under manual for tool measurement
Enable part catcher for cut-off
Enable tailstock
Enable spindle control of main spindle via user interface
Configuring cycles
7.5 Turning
Position of the coordinate system
Turning function screen
105