Siemens SINUMERIK 828D Commissioning Manual page 466

Configuring cycles
7.4 Milling
MD52230 $MCS_M_CODE_ALL_COOLANTS_OFF
= 9
MD52231 $MCS_M_CODE_COOLANT_1_ON
= 8
MD52232 $MCS_M_CODE_COOLANT_2_ON
= 7
MD52233 $MCS_M_CODE_COOLANT_1_AND_2_ON
= -1
MD52281 $MCS_TOOL_MCODE_FUNC_ON[ ]
= -1
[0]
[1]
[2]
[3]
MD52282 $MCS_TOOL_MCODE_FUNC_OFF[ ]
= -1
[0]
[1]
[2]
[3]
Channel-specific cycle setting data
SD55212 $SCS_FUNCTION_MASK_TECH_SET
= 6
Bit 0
Bit 1
Bit 2
98
You define the M function to switch off the coolant that is output when the tool is changed.
You define the M function for coolant 1 that is output when the tool is changed.
You define the M function for coolant 2 that is output when the tool is changed.
You define the M function for coolant 1 and 2 that is output when the tool is changed.
M function is not output.
If both M commands of a function "= -1", the corresponding field is not displayed on the
interface.
M code for tool-specific function 1 ON
M code for tool-specific function 2 ON
M code for tool-specific function 3 ON
M code for tool-specific function 4 ON
M function is output.
If both M commands of a function "= -1", the corresponding field is displayed on the interface.
M code for tool-specific function 1 OFF
M code for tool-specific function 2 OFF
M code for tool-specific function 3 OFF
M code for tool-specific function 4 OFF
Tool preselection active.
The next tool is prepared directly after a tool change.
Notice: For a revolver, the setting data must be set to "0".
Automatic calculation of the thread depth for metric threads.
Take the thread diameter and thread depth from the table.
M code for all coolants Off
M code for coolant 1 On
M code for coolant 2 On
M code for both coolants On
M code for tool-specific function ON
M code for tool-specific function OFF
Cross-technology function screen
Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3
SINUMERIK Operate