Siemens SINUMERIK 828D Commissioning Manual page 552

Configuring cycles
7.9 Measuring cycles and measurement functions
SD54693 $SNS_MEA_T_MAX_STEPS
= 10
If the value = 0, then the "highest point on the longest cutting edge" is not sought, but the measured
*)
value of the contact with the rotating spindle taken.
r
b
n
①
Figure 7-20
General cycle setting data for correction using the correction tables when forming measurements with
rotating spindle.
SD54691 $SNS_MEA_T_PROBE_OFFSET
= 0
= 1
= 2
SD54689 $SNS_MEA_T_PROBE_MANUFACTURER
= 0
= 1
= 2
184
Default value
*)
Effective radius of the tool
Arc distance = SD54692
Maximum number of probe contacts = SD54693
1. Measuring point
Single cutting edge measurement
No data, default value
Correction in the cycle. This is only effective if SD54689 $SNS_MEA_T_PROBE_MANUFAC‐
TURER>0.
Correction using user-defined correction table
No data, default value
TT130 (Heidenhain)
TS27R (Renishaw)
Maximum number of probe contacts for
single cutting edge measurement of the
radius.
Activate the measuring result compen‐
sation
Activates pre-configured compensa‐
tion tables for several tool probe mod‐
els (customer-specific)
Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3
SINUMERIK Operate