Milling; General; Technology Cycles For Milling - Siemens SINUMERIK 828D Commissioning Manual

7.4

Milling

7.4.1

General

All settings for machine and setting data of the standard cycles are also applicable for milling
under ShopMill and turning under ShopTurn.
7.4.2

Technology cycles for milling

Milling function screen
SD52214 $SCS_function_MASK_MILL
Bit 0
Bit 1
Bit 2
Bit 3
Bit 4
Bit 5
Bit 6
SD55214 $SCS_FUNCTION_MASK_MILL_SET
Bit 0
Bit 2
Contour milling (CYCLE63, CYCLE64)
SD55460 $SCS_MILL_CONT_INITIAL_RAD_FIN
= 0
> 0
SINUMERIK Operate
Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3
Enable cylinder surface transformation (ShopMill)
List table to accept blank (on milling machines)
(This bit must only be set if the machine has a rotation axis and a fixed table for the blank
clamping.)
Special treatment of disc mill/saw with multi-edge
(For these tool types the first engagement is selected so that the top edge of the tool touches
reference point Z0 exactly.)
Enable machining inside/outside (ShopTurn)
Enable clamp spindle (C-axis) (ShopTurn)
Enable spindle control of the tool spindle via user interface
Enable spindle control of the main spindle via user interface
Basic setting milling cycles in sync.
Depth calculation of the milling cycles, with or without safety clearance.
= 0 Depth calculation of the milling cycles is performed between the reference plane + safety
clearance and the depth.
= 1 Depth calculation is performed without including the safety clearance.
Bit 2 is effective in the following milling cycles: CYCLE61, CYCLE71, CYCLE76, CYCLE77,
CYCLE79, CYCLE899, LONGHOLE, SLOT1, SLOT2, POCKET3, POCKET4.
The radius is selected so that at the starting point the safety clearance to the finishing allow‐
ance is maintained (default value).
The radius is selected so that at the starting point the value of this channel-specific setting
data to the finishing allowance is maintained.
Configuring cycles
Milling function screen
Milling function screen
Finishing approach circle radius
The radius of the approach circle during the
finishing of contour pockets is affected.
7.4 Milling
95