Cust_Techcyc.spf Manufacturer Cycle - Siemens SINUMERIK 828D Commissioning Manual

Configuring cycles
7.3 Manufacturer cycles
T replacement cycle
If a T replacement cycle is being used, then the following note must be observed:
Note
The CUST_T cycle uses the language command TCA (ToolChangeAbsolut) for the T call and
therefore also has the possibility of inserting tools that have been disabled. The language
command TCA is reconfigured to _TCA for 828D. TCA can be substituted by MD15710
$MN_TCA_CYCLE_NAME.
The following must be observed if working at a machine with T replacement:
● The T preparation cycle must be explicitly called at the specified position.
● If the call is realized using the CUST_T cycle, then the parameter evaluation
($C_TS_PROG, ...) is skipped.
Alternatively, the original TCA language command can be reprogrammed.
References
Further information can be found in the "Function Manual Basic Functions", chapter:
SERUPRO-End-ASUB
7.3.4

CUST_TECHCYC.SPF manufacturer cycle

Function
For technological cycles, the CUST_TECHCYC cycle is called from ShopMill and ShopTurn
cycles, if the machine builder must make certain adaptations to a specific machine (e.g.
activate specific M commands). For instance, this may be necessary in order to retract or
extend part catchers when cutting off parts on lathes or to position a spindle for clamping (only
in JobShop).
The CUST_TECHCYC.SPF cycle can be used to program and execute the necessary
sequences.
84
Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3
SINUMERIK Operate