Siemens SINUMERIK 828D Commissioning Manual page 631

</NEWTOOLDEFAULTVALUECONFIGURATION>
Default values when creating new tools
System variables
Tool size
Size on left
Size on right
Size above
Size below
Magazine location type of the tool
Created outside of the magazine
Created in a magazine location
Tool status
released
SINUMERIK Operate
Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3
<CUTTEDGEPOS_3>
<Default value="93.0" type="double" />
</CUTTEDGEPOS_3>
<CUTTEDGEPOS_4>
<Default value="93.0" type="double" />
</CUTTEDGEPOS_4>
<CUTTEDGEPOS_5>
<Default value="49.0" type="double" />
</CUTTEDGEPOS_5>
<CUTTEDGEPOS_6>
<Default value="49.0" type="double" />
</CUTTEDGEPOS_6>
<CUTTEDGEPOS_7>
<Default value="49.0" type="double" />
</CUTTEDGEPOS_7>
<CUTTEDGEPOS_8>
<Default value="49.0" type="double" />
</CUTTEDGEPOS_8>
</HolderAngle>
</TOOLTYPE_500>
<!-- Initialize coolant 2 of the plunge cutter to switched on -->
<TOOLTYPE_520>
<Coolant2>
<Default value="true" type="bool" />
</Coolant2>
</TOOLTYPE_520>
9.2 Configuring the user interface
Default value
$TC_TP3 1
$TC_TP4 1
$TC_TP5 1
$TC_TP6 1
$TC_TP7 1
$TC_TP7 Location type of the magazine location
$TC_TP8 2
Tool management
263