Siemens SINUMERIK 828D Commissioning Manual page 275

MD52270: $MCS_TM_FUNCTION_MASK
Tool management function mask
MD52270: $MCS_TM_FUNCTION_MASK
Bit 0:
Bit 1:
Bit 2:
Bit 3:
Bit 4:
Bit 5:
Bit 6:
Bit 7:
Bit 8:
Bit 9:
Bit 10:
Bit 11:
Bit 12:
CNC commissioning
Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3
Creating a tool at the magazine location is not permitted.
Tools can only be created outside of the magazine.
Load/unload lock, if the machine is not in the reset state.
Tools can only be loaded/unloaded when the relevant channel is in the reset state.
Load/unload lock for EMERGENCY STOP.
Tools can only be loaded/unloaded when EMERGENCY STOP is not active.
Tool in/out of spindle load/unload locked.
Tools cannot be loaded to or unloaded from the spindle.
Loading is performed directly into the spindle.
Tools are only loaded directly into the spindle.
Reserved
Reserved
Create tool using the T number.
The T number of the tool must be entered when creating a tool.
Hide tool relocation.
The "Relocate tool" function is hidden in the user interface.
Hide magazine positioning.
The "Position magazine" function is hidden in the user interface.
Reactivate tool with magazine positioning.
Before reactivating, the tool is positioned at the loading point.
Reactivate tool in all monitoring types.
When reactivating a tool, all the monitoring types for this tool enabled in the NC are reac‐
tivated. I.e. also the monitoring types that are not set for the relevant tool, but are only in
the background.
Hide reactivating tool.
The "Reactivate tool" function is hidden in the user interface.
9.2 Machine data for the tool management
Tool management
261